649 Fort Worth Avenue Dallas, Texas 75208 Phone: 214 631 4833 Fax: 214 748 5439
Place Mouse Over Part to Reveal Part Number and Additional Information
PN A2499 Hex Boot Seal
You may want to buy the Rapid
Switch Plunger Assy PN 5882, too.
Type 200 Knee
Power Feeds
Please call us at 214 631 4833
to place a parts order.
5882 Rapid Switch Plunger
Assembly. Does NOT include the
A2499 Hex Seal Boot
PN 5064 Light Pipe
Be sure and buy the PN 03103
Light Pipe Grommet, too.
PN 03103 Light Pipe Grommet
Inner Bearing Race. This part is determined by your milling machine. Call us to identify the correct part.
Bevel Gear. This part is determined
by your milling machine. Call us to
identify the correct part.
PN 00502 Bearing, Upper Drive Shaft
PN 3509 Upper Drive Shaft Assembly. Includes pinion gear and bearing.
PN 00984 Tetra Seal (O-Ring)
PN 00555 Wavy Washer. For Upper
Armature Bearing
PN 5528 Spring, Lift Fork
PN 1767-6 Armature and Bearing Assembly
Bearings are part number 00553, 2 needed.
PN 59582 Lift Fork Assembly
PN 59561 Motor Field Assembly
PN 5087 Circuit Board Assembly
PN 6225 Knob, Speed
Control
PN 59578 Assembly, Control Handle. Does NOT include the 01043 Shifting Knob
PN 07535 Circuit Breaker, 5 Amp.
Includes washer and
protective switch nut.
Protective Switch Nut. Included with Circuit Breaker
PN 00555 Wavy Washer. For lower
armature bearing.
PN 01221 Bearing, Lower Drive
Shaft
PN 5530-2 Cam Shaft Assembly
PN 5085 Potentiometer Assembly.
Contains speed pot, bracket, wiring,
and plug. Pot by itself is PN 00541
PN 59581 Rapid Switch Assmbly.
Includes bracket, micro switch, and
wires with connector pins attached.
The microswitch by
itself is PN 03035.
PN 4992 Pin for
5098 Actuator
PN 5098 Actuator,
Reversing Switch
PN 5091-2 Reversing Switch Assembly. The microswitches
are PN 03035.
PN 02451 Lockwasher, #10
4 Required
PN 4737 Zytel Gear and Hub Assembly.
You can buy the plastic gear by itself under
PN 4735.
PN 01009 Nut, Bottom Gear
PN 5089 Power Cord Assembly
PN 2974 Cover, Bottom Gear
Bracket, Limit Switch. This bracket is
determined by your milling machine.
Call us to determine the correct bracket.
PN 2023-10 Limit Switch Assembly.
You get the fully assembled and wired limit switch box and the 4-wire SO cable, ready to use. Order the limit switch bracket and mounting screws separately.
PN 00577 Screw, 4-40 x 7/8. Four
required.
PN 00982 Tolerance Ring. For bottom
armature bearing.
PN 4854-14 Top Housing. Housing is
fully machined and painted, but has no
parts installed on it.
PN 00650 Bearing, Lead Screw
PN 00703 Setscrew #8-32 for
Brush Holders
PN 05287 Screw, Bottom Housing
#10-24, 4 Required
PN 07507 Screw, Field
#8-32 x 3 1/2
